Twin Beds for Kids

Hi! I’m Gladys.

And today we are going to assemble the Rowen Twin Beds.

Make sure you have all the proper pieces and hardware and if anything is missing please call consumer care.

One way to know if you are working with the correct hardware is to compare them with the illustrations that come in the instructions.

Like that! The first step is to attach the Legs to the Center Slat Support.

And for this you will need two 70mm Bolts and the provided Allen Wrench.

Remember to use the short side of the Allen Wrench to tighten the Bolt.

And you are done! The second step it to attach the Headboard Top to the Bottom.

For this you will need four 20mm Bolts and four Cap Nuts and the provided Keys.

Remember to use the short side of the Allen Wrench to tighten the Bolt.

And that’s it! The third step is to attach the two Brackets labeled “A” to the Left Bed Rails.

For this you will need four 16mm Bolts, four Cap Nuts and the provided Keys.

Use the short side of the Allen Wrench to tighten the Bolt.

And you are done! The fourth step is to attach the two Brackets labeled with the letter “B” to the Right Bed Rails.

For this you will need four 16mm Bolts, four Cap Nuts and the provided Keys.

And you are done! The fifth step is to attach the Right Rails to the Left Rails and for this you will need four 105mm Bolts four Wood Dowels eight Crescent Washers four Nuts and the provided Keys.

Make sure to put the Wood Dowels in the outermost holes.

Make sure to use the short side of the Allen Wrench to tighten the Bolt.

And you are done! The sixth step is to attach the Bed Rails to the Center Slat Support.

And for this you will need four 30mm Bolts four Cap Nuts and the provided Keys.

For this step the Bolts are going in from underneath.

And you are done! The seventh step is to attach the Bed Rails to the Footboard and Headboard.

And for this you will need eight 16mm Bolts and the provided Allen Wrench.

If you are working by yourself it is better to start with the Footboard.

And you are done! The last step is to attach the Slats.

And for this you will need eight 32mm Screws and a Phillips Head Screwdriver, which is not provided.

And you are done! Before you use your bed check and make sure all the Bolts are secured.

Congratulations! You’ve just assembled your Rowen Twin Bed.

Source: Youtube

Posted in Uncategorized